Leave a comment

1. 

   cranniev6

   101 Kudos

   09/06/09

   Hi Peter,
   
   Thanks for that information, I will check their site. Fortunately, when I took the body off the chassis, I repaired the rust affected elements (at the time I had a steel fabricating business, so had all the equipment), then the chassis was shot blasted and zinc rich primer sprayed on. this appear to have afforded a lot of protection, but obviously, after the passage of time needs redoing for aesthetic reasons, plus numerous house moves have resulted in some minor damage which will require attention.
   
   My email adress is davidncranwell@aol.com
   
   I shall try to remember to record the history of my rebuild, you never know, someone might find it of interest.
   
   Regards
   
   David

2. 

   cranniev6

   101 Kudos

   09/05/09

   Hi Peter,
   
   I tried to look at your earlier photos of your rebuild, but they would not open.
   
   My V6 is already totally dismantled and has been for 25 years now! Its the rebuild that is now on the agenda, so trying to source all the right bits.
   
   Regards
   
   David

   09/06/09

   Reply from Hillclimber:

   Hi David
   
   Yes I am a bit new to this picture posting, album was full so deleted some of the earlier ones to make room for later pics. Now realise I can start a new album.
   
   If you send me your Email address I will forward missing photos.
   
   Assume you are starting on the Chassis?. I use Frost Restorations for all the rust treatment especially inside the square chassis tubes. Their web page shows Dinatrol RC 900 Rust Off Primer in an aerosol and you can buy a 500mm long tube with rotary nozzle to spray inside the tubes
   
   Please Email me any questions if I have not covered them on my Forum pages.
   
   Regards
   
   Peter Hubbard
   
   

Leave a comment